Octoprint bed visualizer question

This new DIY 3D printer kit is a result of a vast market research and hours of development and engineering. It is an open source project, which means this is a versatile product that you can build upon and make it your own.
Post Reply
Posts: 17
Joined: 23 Sep 2019, 20:13

Octoprint bed visualizer question

Post by finas » 13 Jan 2020, 12:41

What are the commands I should configure in octoprint's bed visualizer plugin?

I am currently using these:
M155 S30
M420 V
M155 S3

Also, can I use the bed visualizer output to manually level the bed ( by adjusting the four corner screws of the bed ) so that the autolevel feature has to correct as little as possible, and how important to print quality is this?

finally, I tried to do just that, and while the corners are almost at the same z height, like 0.03 deviation the center is not, and I am using a glass bed, meaning it should be almost perfectly flat. Why is this happening?

This is the current output of bed visualizer:
newplot.png (48.67 KiB) Viewed 40 times

Post Reply