Calibrating won't stop

Post Reply
Frank33456
Posts: 12
Joined: 04 Sep 2016, 14:31

Calibrating won't stop

Post by Frank33456 » 15 Aug 2018, 10:34

Hello,

finally i've managed to mount the auto-calibration addon to my hpb.

If i start "Set nozzle height", the new nozzle moves to vertikal position, but it don't stop when he reaches the printerbed, he presses the printerbed down!.

At this point, i switched power-off.

Is this normal behaviour or will the 3d-printed tool broke?

I have done the following steps:

- Mounted and connected the add as shown in the video
- Changed the new firmware as shown in the video
- Uploaded the new firmware, it is shown as "Marlin 1.1.1" in the display

Can you tell me, what i have done wrong?

Best regards

Frank

Frank33456
Posts: 12
Joined: 04 Sep 2016, 14:31

Re: Calibrating won't stop

Post by Frank33456 » 15 Aug 2018, 17:24

Hello,

please forget this post, i just hit the wrong connector on the board - now all works fine.

Mea culpa, mea maxima culpa :)


Best regards
Frank

Post Reply