Nozzle extruding 'wavey' material

The versatility of an entry-level 3D printer, engineered to last.
By BEEVERYCREATIVE and Hello 3D Printing World
Post Reply
Posts: 1
Joined: 23 Oct 2018, 17:06

Nozzle extruding 'wavey' material

Post by SCush » 23 Oct 2018, 17:11

When trying to print an object my Prusa is extruding the material in wavey or wiggly lines. I have attached an image.

What is the reason behind this and how can I solve it?
20181023_165259[1].jpg (3.23 MiB) Viewed 3801 times

Posts: 87
Joined: 25 Aug 2015, 14:56

Re: Nozzle extruding 'wavey' material

Post by tgala » 24 Oct 2018, 18:31

Hi @SCush, welcome to the forum!
It looks like you have either too much temperature, too much flow or the nozzle is too far from the bed.
Check this guide to learn how to tackle this problem: ... eshooting/

Let me know how it goes!

Posts: 1
Joined: 02 Jul 2019, 04:58
Location: United Kingdom

Nozzle extruding wavey material

Post by BarryInnob » 04 Jul 2019, 22:32

I have a UM2 at work, and dont have that kind of problem,
when it starts it comes to the front extrudes an amount of filament out of the nozzle before starting.

I could be that that firmware reverses too much after a print, any way to check that ?

Posts: 165
Joined: 12 Dec 2017, 11:44

Re: Nozzle extruding 'wavey' material

Post by DomingosRodrigues » 05 Jul 2019, 11:41

Hello BarryInnob,

The problem seen on the photo posted before is caused by incorrect adjustment of the Z axis endstop.

If you Ultimaker 2 doesn't do it, you did a good job calibration it :) As for the prime line it can also easily be applied on the helloBEEprusa if it is required.

Best regards

Post Reply