Installation on raspberry

BEESOFT is the software that controls your BEETHEFIRST and BEEINSCHOOL line of 3D printers
Post Reply
klorydryk
Posts: 7
Joined: 11 Jan 2016, 21:59

Installation on raspberry

Post by klorydryk » 09 Dec 2017, 17:51

Hi,

I tried to install it on my raspberry, as I already used octoprint to managed my Beeprusa. After installing the Raspbian Stretch Lite, I just had to install
  • git
  • python-pip
to be able to get and setup the BeeSoft.

Unfortunately, It did not discovered my 3dPrinter, and the top-right menu don't open. I'll come back to my original octoprint, and will come back if someone has an idea.

tgala
Posts: 82
Joined: 25 Aug 2015, 14:56

Re: Installation on raspberry

Post by tgala » 11 Dec 2017, 12:11

Hi!
Unfortunately BEESOFT only supports the BEETHEFIRST line of printers (BEETHEFIRST, BEETHEFIRST+, BEETHEFIRST+A, BEEINSCHOOL, BEEINSCHOOL A).
The helloBEEprusa is not supported because it is targeted at makers and thinkerers and it was designed to give the user a broader choice of software and hardware configurations.
I suggest you try the Slic3r slicer (http://slic3r.org/) to generate your gcode and Pronterface (http://www.pronterface.com/) to interact with your 3d printer (along with your LCD screen).
You can check the recommended Slic3r configuration here: viewtopic.php?f=8&t=785

Cheers!

Post Reply