Support for Cura 2.x

BEESOFT is the software that controls your BEETHEFIRST and BEEINSCHOOL line of 3D printers
cropduster
Posts: 11
Joined: 31 May 2016, 21:13

Re: Support for Cura 2.x

Post by cropduster » 09 Jun 2016, 15:35

I will start testing my json profile as soon as I will be back from my travel.

Best regards,

Michael

Filipe

Re: Support for Cura 2.x

Post by Filipe » 20 Jun 2016, 18:44

BEEVERYCREATIVE just posted configuration files for the helloBEEprusa:

https://beeverycreative.com/forum/viewt ... ?f=8&t=389

Testing purposes only. Consider them an early release :)

Report any issues or feedback on the above topic.

cropduster
Posts: 11
Joined: 31 May 2016, 21:13

Re: Support for Cura 2.x

Post by cropduster » 21 Jun 2016, 11:12

Any json config planned for the BeeTheFirst?

Thanks,

Michael

jorge
BEEVERYCREATIVE
Posts: 51
Joined: 30 Jul 2015, 17:18

Re: Support for Cura 2.x

Post by jorge » 19 Sep 2016, 12:51

Hi Michael.

No plans.
BEEVERYCREATIVE
Research and Development Team

Post Reply