Forum under maintenance. Please contact us at customer_service@beeverycreative.com

Ditto printing

The versatility of an entry-level 3D printer, engineered to last.
By BEEVERYCREATIVE and Hello 3D Printing World
Post Reply
ackbahr
Posts:13
Joined:17 Apr 2017, 07:54
Ditto printing

Post by ackbahr » 07 May 2020, 06:39

Hello!
I'm currently printing visors (covid-19...) and I noticed I could print two at the same time (distance-wise) if only I could activate DITTO PRINTING... Has anyone done that yet?
Thanks!

DomingosRodrigues
Posts:197
Joined:12 Dec 2017, 11:44

Re: Ditto printing

Post by DomingosRodrigues » 01 Sep 2020, 15:46

Hello Ackbahr,

Ditto printing on the helloBEEprusa would have limited usefullness as it would make adhere to the plate really complicated as no leveling can be used and the plate needs to be perfectly flat with both nozzles, other than that i'm not sure that the plate size of the helloBEEprusa can be used to print 2 visors at a time.
There isn't official support as it would be unusable for the end user.

You can download the firmware and recompile activating that feature but I wouldn't recommend it.

Best regards
Domingos Rodrigues

Post Reply