Issues while printing Shafts with Layer height = 1.0

This new DIY 3D printer kit is a result of a vast market research and hours of development and engineering. It is an open source project, which means this is a versatile product that you can build upon and make it your own.
Post Reply
RNowak
Posts: 2
Joined: 23 Jan 2020, 20:30

Issues while printing Shafts with Layer height = 1.0

Post by RNowak » 23 Jan 2020, 20:40

Hi,

having some issues while printing Shafts with Layer height = 1.0. While using orginal settings. It is not vertical as it should. It looks like it was breaking apart in middle.
20200120_145820.jpg
20200120_145820.jpg (2.49 MiB) Viewed 196 times
But when printing with 1.5 layer it is much better.

Using B2x300 Cura profile PLA.

Best regards,
RNowak

srodrigues
Posts: 18
Joined: 04 Mar 2019, 13:41

Re: Issues while printing Shafts with Layer height = 1.0

Post by srodrigues » 03 Feb 2020, 11:31

We have moved your message from the other topic to here, since this is a different subject.
I don't know why there is that difference in the printer quality, when you changed the layer height. Your picture is not very clear. What would happen for other layer heights?

Post Reply