Forum under maintenance. Please contact us at customer_service@beeverycreative.com

3D Print Finishing Tool

General discussion, news and announcements
User avatar
GabrielLuke
Posts:1
Joined:09 Sep 2020, 15:03
Re: 3D Print Finishing Tool

Post by GabrielLuke » 09 Sep 2020, 15:06

Waterpik's are great for removing support material from 3d prints. For smoothing and finishing, sandpaper and acetone vapour baths. I checked some vinyl for car decals here. A good set of hemostats/pliers for pulling off stubborn bits of support goes a long way as well.

Locked