Page 1 of 1

[COMMUNITY] INFO DOCUMENT - CALIBRATION GUIDE

Posted: 09 May 2016, 20:28
by HALFORD
Hello All,
Please find the enclosed documentation guide regarding Calibration of your Hello BEE Prusa;

1. Microsoft Word Document
2. Adobe PDF of the above document
3. Adobe PDF drawing of the 20mm calibration cube
4. Model .stl of the 20mm Calibration cube
5. Hello BEE Prusa settings file from Cura (.ini)

USE THIS LINK; https://drive.google.com/file/d/0B0RFSY ... sp=sharing

any questions please contact me.
Regards
Paul Halford

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 10 May 2016, 10:43
by jorge
Hi Paul.

Great work and thanks for sharing <3

I suggest to add date of last update to the document.

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 11 May 2016, 10:22
by Filipe
Amazing work :)

With some modifications, it can be used for all version of hBp.

Thanks for sharing with the community!

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 15 May 2016, 04:13
by Ryche
Thanks for posting. I went through the instructions this weekend and it upped the quality of my prints.

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 15 May 2016, 21:38
by HALFORD
Thanks for the feedback, Happy to help.
Would this guide have been helpfull when assembly was complete?
Which version of HBP do you have

Halford

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 16 May 2016, 20:13
by HALFORD
Ryche, can you provide before and after photos to see the differance?
Regards

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 29 Jun 2016, 03:14
by Kike
HALFORD this guide is AMAZING. I thank you from the depths of my hearth for making it. It helped me fine tune the printer a little better, and most important, it taught me a lot about how 3D Printing works.

This post should be sticky

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 29 Jun 2016, 10:41
by Filipe
Kike wrote:HALFORD this guide is AMAZING. I thank you from the depths of my hearth for making it. It helped me fine tune the printer a little better, and most important, it taught me a lot about how 3D Printing works.

This post should be sticky
And so it was done :)

Re: INFO DOCUMENT - CALIBRATION GUIDE

Posted: 15 Oct 2017, 16:08
by Accetta
Filipe wrote:Amazing work :)

With some modifications, it can be used for all version of hBp.

Thanks for sharing with the community!
That's a good idea Filipe! I'm going to try and do this.

Re: [COMMUNITY] INFO DOCUMENT - CALIBRATION GUIDE

Posted: 18 Nov 2017, 19:10
by RickRick
Edit Ignore this, the gaps were present in slicr due to me setting the wrong nozzel size 0.5 not 04

So i'm finally printing the calibration cube I was really close after previous attempts at calibrating but now i'm getting right down to the correct size and wall thickness however the corners are not meeting up theres a fine slit down each one any ideas?