Page 3 of 3

Re: Not able to print anything

Posted: 01 Jul 2016, 20:40
by Andre_A
Hi Joao,
Do you have any news?

Re: Not able to print anything

Posted: 18 Jul 2016, 09:24
by siquenique
Hi Andre,

All solved, my main issue now is that when I print most of the times the print doesn't end because is not feeding anymore. It stops feeding in the middle of the print. Are you aware of any tip for this?

Regards,
Joao

Re: [SOLVED] Not able to print anything

Posted: 27 Jun 2017, 08:27
by paylituzu
That doesnt really answer my question, at least the one with the second extruder going up after i start printing. They have the same level as i mentioned and than when i start printing the right adjustment next to the stepper motor goes out of synch.

GCLUB มือถือ
goldenslot

Re: [SOLVED] Not able to print anything

Posted: 27 Jun 2017, 10:25
by MrDoom
Hello paylituzu,

can you explain you problem a liitle better, what do you mean by "the right adjustment next to the stepper motor goes out of synch"? does the second extruder not move to where the first one was printing? if so have you calibrated you extruder offset?