the filament stops in the first layer !

The versatility of an entry-level 3D printer, engineered to last.
By BEEVERYCREATIVE and Hello 3D Printing World
Post Reply
Posts: 2
Joined: 14 Jan 2017, 10:25

the filament stops in the first layer !

Post by jimis07 » 13 May 2018, 12:19

i have a problem with my hello bee prusa . the extruder stops in the first layer again and again ..... any help plz

Posts: 82
Joined: 25 Aug 2015, 14:56

Re: the filament stops in the first layer !

Post by tgala » 14 May 2018, 10:19

Hi @jimis07,
The first thing I would check is if the nozzle temperature is correct (depends on the material but I would say that at 200ºC it should be able to extruded consistently).
Can you try to pre-heat the extruder, load some filament, check if it is flowing properly and then start a print and monitor the extruder temperature for a while?

Posts: 223
Joined: 01 Apr 2017, 10:01

Re: the filament stops in the first layer !

Post by MrDoom » 14 May 2018, 10:51

Hello Jimis07,

As tgala stated check the nozzle temperature you are using, also I would recommend you take a good look at the document present here:

It contains a compilation of the most common assembly errors and also some maintenance tips that improve printing, I had problems before I followed that guide.

Also there are some brands of PLA that print very badly unless they are oiled!

Post Reply