Page 1 of 1

E0 and E1 are not working - suddenly

Posted: 09 Jan 2020, 10:22
by Mic_Hazelburn
Hello friends,

I have a new problem at home. The feed suddenly stopped when printing. The E0 stopped moving. I checked all the cables but found nothing. When I go to manual feeding, I feel the gear on the E0 wobbles only very slightly and minimally - but I could only be an imagine.

So I decided to set update the firmware to the new stand - ah! E0 worked. So I started a new Wizard, put new filament in and than - nothing. Again E0 and E1 are not working. All other steppers are doing what they should.

What can I do now? Update again?

Re: E0 and E1 are not working - suddenly

Posted: 19 Jan 2020, 11:42
by jaume.figueres
Hi,
does you find any solution, here E1 (E0 never worked, I'm waitinf for a new mother board) motor has suddenly stoped working too.

I was wonderingif you found any solution.

thanks

Re: E0 and E1 are not working - suddenly

Posted: 20 Jan 2020, 11:10
by Samuel
Hi,
we have a same problem.

Any solution?

Re: E0 and E1 are not working - suddenly

Posted: 03 Feb 2020, 11:23
by srodrigues
Can you print with one extruder?
Please contact the customer support: customer_service@beeverycreative.com for technical help.