Search found 8 matches

by bbrito
02 Jan 2020, 13:59
Forum: helloBEEprusa
Topic: Ceramic Cartridge Heater are 12v or 24v?
Replies: 2
Views: 978

Ceramic Cartridge Heater are 12v or 24v?

Good afternoon

the Ceramic Cartridge Heater are 12v or 24v?
by bbrito
20 May 2017, 22:35
Forum: helloBEEprusa
Topic: Problems
Replies: 10
Views: 11909

Re: Problems

Mr Doom sorry for the delay but I have been testing these days to give correct feedbacck after cutting the pins of the end stops everything flawless thank you very much

Thank you very much Problem Solved
by bbrito
10 May 2017, 23:39
Forum: helloBEEprusa
Topic: Problems
Replies: 10
Views: 11909

Re: Problems

I'm going to cut the pins in the 3 endstops.

Print by SD card

Thank you
by bbrito
08 May 2017, 12:34
Forum: helloBEEprusa
Topic: Problems
Replies: 10
Views: 11909

Re: Problems

What happens is that it starts randomly, as if you press the reset button
by bbrito
07 May 2017, 11:59
Forum: helloBEEprusa
Topic: Problems
Replies: 10
Views: 11909

Problems

Hi, I have a problem with a hello bee prusa that needs help. The printer when it is warm reset or sometimes in the middle of the printing, does anyone know what it is? I read it and say that in prusa 3 the propblem to and in the "RAMPS" or in the main plate, confirmation? If this is where I buy this...
by bbrito
15 Feb 2017, 10:24
Forum: helloBEEprusa
Topic: two extrsuion/color print
Replies: 2
Views: 3795

Re: two extrsuion/color print

The blank is in the extruder 0 and the black one is in the extruder 1 when it says alignment on the table refers to the height of one extruder to the other because it has already printed the alignment and for the alignment x and y in the STL. the White
by bbrito
12 Feb 2017, 18:21
Forum: helloBEEprusa
Topic: two extrsuion/color print
Replies: 2
Views: 3795

two extrsuion/color print

Good afternoon, I have a problem I started to print with the 2 extruder but when I print the demonstration cone there is a fault between the two colors as seen in the figure someone knows how best and what the correct settings

Image