Page 1 of 1

Nozzels

Posted: 02 May 2017, 14:26
by peet
Hello,

I've seen that you now offer different nozzel sizes in your online shop as well as the coresponding blog post.
Do I understand correctly, that I cannot use the larger 0.6mm nozzel with my beethefirst (no '+')printer?

Thanks allot for you answer!

Re: Nozzels

Posted: 15 Dec 2017, 11:03
by MrDoom
Hello peet,

As far as I understood it they don't recommend the 0.6mm nozzle for the BTF non plus version, hence beesoft does not support it, but I suppose you could make it work by generating the gcode on other slicers such as cura etc, outside of beesoft and then importing it :)