[SOLVED] hotend don't heat enought

BEESOFT is the software that controls your BEETHEFIRST and BEEINSCHOOL line of 3D printers
Post Reply
tutu10
Posts: 1
Joined: 29 May 2019, 09:48

[SOLVED] hotend don't heat enought

Post by tutu10 » 29 May 2019, 09:58

Hey,

I have some problem with my printer. After slicing and transferring the model the printer starts to heat. When it reaches 198 degrees Celcius it stops and will not increase anymore. I have removed the old PLA and make sure that the nozzle is not clogged. Any ideas what could have happened?

System specs:
Printer Beethefirst "old"
Firmware Installed MSFT-BEETHEFIRST-10.1.0
Beesoft 4.0

All the best,

DomingosRodrigues
Posts: 132
Joined: 12 Dec 2017, 11:44

Re: [SOLVED] hotend don't heat enought

Post by DomingosRodrigues » 29 May 2019, 17:57

Hello tutu10,

The problem you are reporting appears to be due to a transition from an old firmware to the new version, during the installation of the new firmware it did not reset it's memory causing the printer to have incorrect internal values that prevent the correct heating.

To fix this please open Beesoft 4.0 and connect it to your printer, then press the "Help" button on the top left and select the option "Reset printer configuration", this will force the printer to reset it's internal values according to the firmware's defaults fixing your issue.
BEESOFT RESET.PNG
BEESOFT RESET.PNG (8.75 KiB) Viewed 577 times

Best regards
Domingos Rodrigues

Post Reply