Can't select Filament Type

BEESOFT is the software that controls your BEETHEFIRST and BEEINSCHOOL line of 3D printers
Post Reply
NickHart
Posts: 4
Joined: 02 Mar 2019, 09:58

Can't select Filament Type

Post by NickHart » 02 Mar 2019, 10:03

Hello,

Running software version 1.4.10 connected to a BEETHEFIRST with firmware 3.35.0

When I try the change filament wizard I get a drop down on the first page for "Select Filament Type" but when I click the drop down there are no options other than "Select Filament Type"

Is there something I'm missing?

Thanks

Nick

DomingosRodrigues
Posts: 132
Joined: 12 Dec 2017, 11:44

Re: Can't select Filament Type

Post by DomingosRodrigues » 04 Mar 2019, 11:27

Hello NickHart,

it appears that your printer lost it's internal configuration and needs to be reset, turn on beesoft, click on help on the top right side and select "Reset printer configurations" and that should make the printer ready for operation once again.

Best regards
Domingos Rodrigues

NickHart
Posts: 4
Joined: 02 Mar 2019, 09:58

Re: Can't select Filament Type

Post by NickHart » 09 Mar 2019, 13:00

Thank you I'm up and running now.

Nick

Post Reply