Search found 3 matches

by TracyJonSargeant
25 Apr 2019, 19:11
Forum: B2X300
Topic: Error Code EC51 after firmware update
Replies: 2
Views: 878

Error Code EC51 after firmware update

After assembling the 3d printer I ran through the self-test wizard and it went through most of the wizard and received a message about the bed. I noticed that the Z motors never moved during the self-test. I emailed support and received the instructions to update the firmware and perform some other ...
by TracyJonSargeant
16 Apr 2019, 01:57
Forum: B2X300
Topic: Auto-leveling sensor placement
Replies: 3
Views: 1153

Re: Auto-leveling sensor placement

Thanks for your reply. I think the issue is with the Z stepper motors since they do not seem to move the Z-axis at all. My guess is that either the stepper motors are DOA or the wiring harness is bad since they splice the four wires together from each Z-axis stepper motor to plug into one port on th...
by TracyJonSargeant
14 Apr 2019, 22:45
Forum: B2X300
Topic: Auto-leveling sensor placement
Replies: 3
Views: 1153

Auto-leveling sensor placement

I cannot seem to find a close-up picture of the leveling sensor attached to the bottom of the extruder mount. I would expect the sensor arm to be able to rotate down so the sensor tip can locate the distance from the bed surface. Maybe I am missing something but this does not look right to me. Has a...